distance changes, etc… Participants added via the application will be added to your participant list in USU when you publish results, so you may need to remove them before publishing when you are just testing. Any changes made to participant records in the App are reflected in your participant list on when you publish results from the app, i.e. Note: You can record times, change distances, add participants, and publish results. Once your code has been created, you will add the code to the application ( guide here) Test General Functionality of the app # Recording a fixed time event (Loops, i.e.Please see the guide that applies to your event: Once bibs have been assigned, it’s time to get your code. Then you will need to reset the app for changes to be reflected. If you add a participant or allow a participant to register after bibs have been assigned and you would like to assign a bib to that runner individually, you must do so in the participant record ( Guide here).If you see the error “NO BIB FIX ONLINE”, and you have assigned bibs, then reset the app. If you add the code in the application and assign bibs afterward, you will need to reset the app to see the bib assignments.Once bibs have been assigned and your data has been loaded to the application, you will not be able to reuse any bib numbers that have already been assigned to a runner. The application will not let you use the bib number again, and if you let a runner use the bib number that is already in use in the application, you will need to manually record their finish time, and manually add the time using the final results editor on.distance changes, etc… Participants added via the application will be added to your participant list in USU when you publish results. If changes are made to participants in USU after bibs have been assigned, the app must be reset. It’s advised that you do this testing at least a week prior to your event so that you have time to properly reset and prepare.Īfter bibs have been assigned in Ultrasignup, changes made to participants should take place in the application. We are working on a development of this product which will have the same features but better accuracy (we are targeting +/- 0.5 seconds) Subscribe to our newsletter to get updates.If you are planning to use the Ultrasignup race timer to time your event this guide will walk you through testing and resetting the application and your results on Ultrasignup before your event. Location – To access GPS signal Development Phone storage – To store times, laps and routes +/- 1.5 seconds – A clear view of the sky helps accuracy a lot. Once you have a completed you first lap or route, it is stored and every time you start a new lap or route and pass a split point, your time up to that point will be shown on the screen as plus or minus versus the best lap, just like in Gran Turismo. You put in your start point, finish point and at least one split point and that’s it. ![]() ![]() So we came up with our own app, MoviChip Time Trial. We tried a few different Android GPS lap timers but as it shows in the video, at least in our experience, they either didn’t do what we wanted, were unreliable or both hence our motivation to make our own.
0 Comments
Leave a Reply. |